6. (Figure 3): Remove the two Bushing Retaining Clips.
Lift out the clip
Insert the tip of a
screwdriver into the
notch in the Bushing
7. (Figure 4): Slide each Drive Roll to the left to unseat the Right
Bearing and expose the Drive Pulley
8. Lift out and replace any malfunctioning Idler Roll Assembly.
B
Lift out and replace any
malfunctioning Idler Roll
Assembly
Slide each Drive Roll to the
left to unseat the Right
Bearing
Figure 4. Removing the Idler Roil Assembly
01096A-COB
Figure 3. Removing the Bushing Retaining Clips
REP 4.1.18
4/97
4-34 7356 SCANNER
A
To Next Page
Loading...
