February 2013
6-280
ColorQube® 9303 Family
dC361
General Procedures/Information
NVM Restore
1. If necessary, connect the USB drive to the USB port on the left side of the machine.
2. Enter service mode, GP 1.
3. Select the Adjustments tab.
4. Select dC361 NVM Save and Restore.
The screen displays the NVM data.
5. Restore the NVM data.
a. Select the entry from the available NVM data on the hard drive.
NOTE: NVM data on a USB device should be copied to the hard drive before it can
be restored.
b. Select Restore Machine NVM.
The status region at the top of the screen will report that the NVM was restored suc-
cessfully.
6. Select Close to return to the service mode window.
7. Select Call Closeout to exit service mode.
To Next Page
Loading...
Need help?
General
