February 2013
6-303
ColorQube® 9303 Family
Finisher (HVF) Tags, Finisher (HVF) Tags
General Procedures/Information
TAG: F-005
CLASS: 5
NAME: LCSS elevator motor encoder sensor.
PURPOSE: A new sensor with an improved response time.
KIT NUMBER: -
PARTS LIST ON: -
TAG: F-007
CLASS: 5
NAME: LCSS rear frame cutout modified.
PURPOSE: Change to the cutout in the rear frame to accommodate all configurations of
hole punches
KIT NUMBER: -
PARTS LIST ON: -
TAG: F-009
CLASS: 4
NAME: Sharp edges removed from area 5 (safety)
PURPOSE: To make safe the customer interaction area around the hole punch.
KIT NUMBER: -
PARTS LIST ON: -
TAG: F-010
CLASS: 4
NAME: 20 ohm tamper motor
PURPOSE: To eliminate the tamper motor from stalling.
KIT NUMBER: -
PARTS LIST ON: PL 12.45
TAG: F-011
CLASS: 4
NAME: Re-routed harness
PURPOSE: To improve the routing of the staple harness by using a longer harness.
KIT NUMBER: -
PARTS LIST ON: -
TAG: F-013
CLASS: 4
NAME: LCSS bin 1 kit
PURPOSE: Modified angle to the output tray to reduce problem with paper curl.
KIT NUMBER: -
PARTS LIST ON: PL 12.10 Item 10
TAG: F-016
CLASS: 3
NAME: LCSS Paddle assembly
PURPOSE: New paddle wheel shaft assembly featuring increased grip paddles that are
now a clip in fitting.
KIT NUMBER: -
PARTS LIST ON: PL 12.25 Item 4
TAG: F-050
CLASS: 5
NAME: Restriction of Hazardous Substances (RoHS)
PURPOSE: To identify RoHS compliant machines. Refer to GP 26.
KIT NUMBER: -
PARTS LIST ON: -
To Next Page
Loading...
Need help?
General
