Yamaha F40B - Removing the Propeller Shaft Housing Assembly; Disassembling the Propeller Shaft Assembly; Disassembling the Propeller Shaft Housing Assembly

LOWR
Lower unit
6-7 67C3K11
Removing the propeller shaft
housing assembly
1. Remove the bolts 1 from the propeller
shaft housing.
2. Remove the propeller shaft housing
assembly 2.
NOTE:
• Insert flat-head screwdrivers between the
propeller shaft housing assembly 2 and
the lower case to pry the assembly loose.
• If the propeller shaft housing assembly 2 is
stuck to the lower case, use the special ser-
vice tools. See “Backlash” (6-26).
Disassembling the propeller shaft
assembly
1. Remove the shift plunger 1 from the
propeller shaft 2.
2. Remove the spring 3, and then remove
the cross pin 4 and dog clutch 5.
3. Pull out the spring 6 from the propeller
shaft 2.
Disassembling the propeller shaft
housing assembly
1. Remove the reverse gear and shim(s).
2. Remove the ball bearing.
CAUTION:
Do not reuse the bearing, always replace
it with a new one.
S6AU6009
1
2
S67C6010
F
6
3
4
2
5
1
Bearing separator 1: 90890-06534
Stopper guide plate 2: 90890-06501
Stopper guide stand 3:
90890-06538
Bearing puller assembly 4:
90890-06535
S67C6087
4
3
2
1
S67C6013
3
2
4