GEN
INFO
General information
1-15 67C3K11
Checking the gear oil level
1. Check the gear oil level.
NOTE:
If the oil is at the correct level, a small
amount of oil should overflow out of the
check hole when the gear oil check screw is
removed.
Checking the battery (E and W
model)
1. Check the battery capacity, electrolyte
level, and specific gravity of the electro-
lyte.
2. Check that the positive and negative bat-
tery cables are securely connected.
Connecting the throttle cable and
shift cable
NOTE:
To adjust the throttle cable and shift cable,
see “Adjusting the throttle cable” (3-8) or
“Checking the gear shift operation” (3-9).
1. Set the shift lever or remote control lever
to the N position and the throttle grip or
throttle lever to the fully closed position.
2. Turn the throttle cam 1 clockwise until
the cam contacts the fully closed stopper
a on the throttle cam bracket 2 and
hold it in that position. Connect the throt-
tle cable 3 to the throttle cam, and then
install the clip 4.
3. Check that the shift arm 5 is in the N
position as shown. Connect the shift
cable 6 to the shift arm, and then install
the clip 7.
WARNING
The shift/throttle cable joint must be
screwed in a minimum depth of 8.0 mm
(0.31 in) b.
Recommended battery capacity:
CCA/EN: 430 A
20HR/IEC: 70 Ah
Electrolyte specific gravity:
1.280 at 20 °C (68 °F)
S67C1019
S67C1020
4
3
2
a
1
S67C1021
7
6
5
d
c
N
RF
S67C1047
b
To Next Page
Loading...
