Yealink T5 Series

Administrator’s Guide for SIP-T58V/T58A/T56A/CP960 IP Phones
216
(Enabled). The value configured by the parameter “account.X.dialplan.digitmap.active.on_hook_dialing”
takes precedence over that configured by this parameter. It is not applicable to CP960 phones.
Permitted
Values
0-Disabled
1-Enabled
Default 0
Parameter dialplan.digitmap.apply_to.on_hook_dial <y0000000000xx>.cfg
Description
It enables or disables the entered number to match the predefined string of the digit map after pressing a
send key when dialing on-hook or pressing the DSS key (for example, speed dial, BLF or prefix key).
Note: It works only if “dialplan.digitmap.enable” or “account.X.dialplan.digitmap.enable” is set to 1
(Enabled). The value configured by the parameter “account.X.dialplan.digitmap.apply_to.on_hook_dial”
takes precedence over that configured by this parameter. On-hook dialing is not applicable to CP960
phones.
Permitted
Values
0-Disabled
1-Enabled
Default 1
Parameter dialplan.digitmap.apply_to.directory_dial <y0000000000xx>.cfg
Description
It enables or disables the digit map to be applied to the numbers dialed from the directory.
Note: It works only if “dialplan.digitmap.enable” or “account.X.dialplan.digitmap.enable” is set to 1
(Enabled). The value configured by the parameter “account.X.dialplan.digitmap.apply_to.directory_dial”
takes precedence over that configured by this parameter.
Permitted
Values
0-Disabled
1-Enabled
Default 1
Parameter dialplan.digitmap.apply_to.history_dial <y0000000000xx>.cfg
Description
It enables or disables the digit map to be applied to the numbers (received calls or missed calls) dialed
from call history list.
Note: It works only if “dialplan.digitmap.enable” or “account.X.dialplan.digitmap.enable” is set to 1
(Enabled). The value configured by the parameter “account.X.dialplan.digitmap.apply_to.history_dial”
takes precedence over that configured by this parameter.
Permitted
Values
0-Disabled
1-Enabled
Default 0
Parameter dialplan.digitmap.apply_to.forward <y0000000000xx>.cfg
Description
It enables or disables the digit map to be applied to the numbers that you want to forward to when per-
forming call forward.
Note: It works only if “dialplan.digitmap.enable” or “account.X.dialplan.digitmap.enable” is set to 1
(Enabled). The value configured by the parameter “account.X.dialplan.digitmap.apply_to.forward” takes
precedence over that configured by this parameter.
Permitted
Values
0-Disabled
1-Enabled, the incoming calls will be forwarded to the desired destination number according to the string
of the digit map.