Yealink T5 Series Administrator's Guide

Administrator’s Guide for SIP-T58V/T58A/T56A/CP960 IP Phones
376
l If it is the first time you capture the phone’s current screen using the computer, the browser will display “Remote
control forbidden”, and the phone screen will prompt the message “Allow remote control?”.
Tap OK on the phone to allow remote control. The phone will return to the previous screen.
Refresh the web page.
The browser will display an image of the phone’s current screen. You can save the image to your local system.
l Else, the browser will display an image of the phone’s current screen directly. You can save the image to your
local system.
Note
Frequent capture may affect the phone performance. Yealink recommends you to capture the phone screen display within
a minimum interval of 4 seconds.
Example: Placing a Call via Web User Interface
Procedure
1. Navigate to Directory->Phone Call Info.
2. Select the desired account from the pull-down list of Outgoing Identity.
3. Enter the callee’s number in the Dial Number field.
4. Click Dial to dial out the number.
The web user interface prompts “Call Success” and the phone will automatically dial out the number.
You can click Hang Up to end the call.
If it is the first time you place a call via web user interface, the LCD screen will prompt the message “Allow remote con-
trol?”. Tap OK on the phone to allow remote control and then the phone will automatically dial out the number.
Note
You can also place an IP direct call via web user interface. The IP phone supports either IPv4 or IPv6 address..
Voice Mail
Yealink phones support voice mail.

Yealink T5 Series Specifications

General

Brand	Yealink
Model	T5 Series
Category	IP Phone
Language	English