Yealink T5 Series

Advanced Features
353
Related Topics
Line Keys Configuration
Programmable Keys Configuration
State Monitor for Intercom Contact
State Monitor for Intercom Contact
You can make the phone to monitor a specific intercom user for state changes (busy or idle). When the monitored user
receives an incoming call, the supervisor can tap the intercom key to pick up the call directly. The phones support this
feature using a SUBSCRIBE/NOTIFY mechanism as specified in RFC 3265.
Note
If you want to use the Intercom key to pick up a call, you need to configure the pickup code for the Intercom key, for
example, “linekey.X.extension = *97”.
Topics
State Indicator of Intercom Contact
State Monitor for Intercom Contact Configuration
State Indicator of Intercom Contact
The following table shows the icon indicator associated with the Intercom key:
Icons Description
The monitored user is idle.
The monitored user receives an incoming call.
The monitored user is dialing.
The monitored user is talking.
The monitored user does not exist.
State Monitor for Intercom Contact Configuration
The following table lists the parameters you can use to configure state monitor for intercom contact.
Parameter features.intercom.led.enable <y0000000000xx>.cfg
Description
It enables or disables the phone to display different intercom key icons when the status of monitored
user changes.
Permitted
Values
0-Disabled
1-Enabled
Default 0
Parameter features.intercom.subscribe.enable <y0000000000xx>.cfg
Description
For T58V/T58A/T56A phones:
It enables or disables intercom subscription for the phones.
For CP960 phones:
It enables or disables the phones to update corresponding information according to the status returned
by the intercom subscription.
Permitted
0-Disabled