Chapter 3 PERFORMING MEASUREMENTS
3-48
Changing the Plug Check Setting
The plug check function checks the connection condition between the instrument and
optical fiber to be measured.
When this function is enabled (ON), emission of laser from the instrument will be
prevented if the optical fiber is not connected or it is connected but not properly.
The plug check setting can be changed as explained below.
♦ Example: “OFF” → “ON”
1. Locate the cursor to “PLUG CHECK” by using the rotary knob or the arrow key.
2. Press [ENTER].
A selection window will appear.
*: Indicates the default setting.
3. Locate the cursor to “ON” by using the rotary knob or [S] / [T].
4. Press [ENTER] to register the change made to the plug check function setting.
5. Press [F4] (DONE) to register the changes made to the measurement
conditions.
When changing the condition for two or more items, it is recommended to change
the condition for each item first and then press [F4].
Refer to the notes given on changing the measurement conditions (page 3-50).
TIP
Refer
TIP
*OFF Disables the plug check function.
Selectable
plug check setting
ON Enables the plug check function.
To Next Page
Loading...
Need help?
General
