Chapter 3 PERFORMING MEASUREMENTS
3-47
4. Press [ENTER] to register the change made to the fiber end threshold.
5. Press [F4] (DONE) to register the changes made to the measurement
conditions.
When changing the condition for two or more items, it is recommended to change
the condition for each item first and then press [F4].
Refer to the notes given on changing the measurement conditions (page 3-50).
Changing the Filter Setting
For the method of changing the filter setting, refer to page 3-59.
TIP
Refer
Refer
To Next Page
Loading...
Need help?
General
