Chapter 3 PERFORMING MEASUREMENTS
3-82
6-Point Method
The 6-point method allows you to check splice loss for the desired events using six
markers.
The distance from the previous event can be found by performing this method.
In this explanation, it is assumed that four markers (
1
to
3
, Y2) have already been set.
For the method of setting four markers, refer to page 3-78.
1. Move
1
.
1-1. Locate the cursor to the event just before the current one by turning the
rotary knob.
For the position for marker
1
, refer to page 3-84.
1-2. Press [F1] (
1
).
The position of marker
1
will move.
TIP
Refer
To Next Page
Loading...
Need help?
General
