Chapter 2 CHANGING SYSTEM SETTINGS
2-17
The trace form can be changed as explained below.
♦ Example: “DECIMATION” → “MAXIMUM”
1. Locate the cursor to “TRACE FORM” by using the rotary knob or the arrow key.
2.
Press [ENTER].
A selection window will appear.
3. Locate the cursor to “MAXIMUM” by using the rotary knob or [S] / [T].
4. Press [ENTER] to register the change made to the trace form.
The change will not be registered if [ESC] is pressed instead of [ENTER].
*DECIMATION
MEAN
MAXIMUM
Selectable
race forms
ENVELOPE
*: Indicates the default setting.
Caution
TIP
To Next Page
Loading...
