Chapter 2 CHANGING SYSTEM SETTINGS
2-18
Changing the Distance Unit
The distance unit can be changed as explained below.
♦ Example: “km” → “mile”
1. Locate the cursor to “DIST. UNIT” by using the rotary knob or the arrow key.
2.
Press [ENTER].
A selection window will appear.
3. Locate the cursor to “mile” by using the rotary knob or [S] / [T].
4. Press [ENTER] to register the change made to the distance unit.
The change will not be registered if [ESC] is pressed instead of [ENTER].
*km
mile
Selectable
distance units
kf
*: Indicates the default setting.
Caution
TIP
To Next Page
Loading...
