Chapter 2 CHANGING SYSTEM SETTINGS
2-21
Changing the Number of dB Display Digits
The number of dB display digits can be changed as explained below.
♦ Example: “∗∗.∗∗∗” → “∗∗.∗∗”
1. Locate the cursor to “dB DIGIT” by using the rotary knob or the arrow key.
2.
Press [ENTER].
A selection window will appear.
3. Locate the cursor to “∗∗.∗∗” by using the rotary knob or [S] / [T].
4. Press [ENTER] to register the change made to the number of dB display digits.
The change will not be registered if [ESC] is pressed instead of [ENTER].
∗∗.∗
Displays dB with one decimal place.
∗∗.∗∗
Displays dB with two decimal places.
Selectable
dB digits
*∗∗.∗∗∗
Displays dB with three decimal places.
*: Indicates the default setting.
Caution
TIP
To Next Page
Loading...
