Chapter 2 CHANGING SYSTEM SETTINGS
2-27
Changing the Lockout Setting
The lockout function is to prevent the preset measurement conditions and system settings
being changed by other operators. If this function is enabled, the measurement conditions
and system settings cannot be changed.
The lockout setting can be changed as explained below.
♦ Example: “OFF” → “ON” (setting the lockout code to “7260”)
1. Locate the cursor to “LOCKOUT” by using the rotary knob or the arrow key.
2. Press [ENTER].
A selection window will appear.
3. Locate the cursor to “ON” by using the rotary knob or [S] / [T].
*OFF Disables the lockout function. Selectable
lockout settings
ON Enables the lockout function.
*: Indicates the default setting.
TIP
To Next Page
Loading...
