Chapter 21 IP Setup
GS1920v2 Series User’s Guide
124
Figure 79 SYSTEM > IP Setup > IP Setup > Add/Edit
The following table describes the labels in this screen.
21.4 Network Proxy Configuration
The proxy server of an organization may prohibit communication between the Switch and NCC (Nebula
Control Center) (See Section 18.1 on page 111). Use this screen to enable communication between the
Switch and NCC through the proxy server.
Figure 80 Network Proxy Configuration Application
As of this writing, this setting only allows communication between the Switch and the NCC.
Table 35 SYSTEM > IP Setup > IP Setup > Add/Edit
LABEL DESCRIPTION
IP Address Enter the IP address of your Switch in dotted decimal notation, for example, 172.21.40.x. This is
the IP address of the Switch in an IP routing domain.
IP Subnet Mask Enter the IP subnet mask of an IP routing domain in dotted decimal notation, for example,
255.255.252.0.
Default
Gateway
Enter the IP address of the default outgoing gateway in dotted decimal notation, for example
172.21.43.254.
VID Enter the VLAN identification number to which an IP routing domain belongs.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to reset the fields to your previous configuration.
To Next Page
Loading...
