ZyXEL Communications GS1920v2 Series - Add;Edit DHCPv6 Relay

Chapter 53 DHCP
GS1920v2 Series User’s Guide
339
53.7.1 Add/Edit DHCPv6 Relay
Use this screen to add/edit DHCPv6 relay settings for a specific VLAN on the Switch. Click Add/Edit, or
select an entry and click Add/Edit in the NETWORKING > DHCP > DHCPv6 Relay screen to display this
screen.
Figure 249 NETWORKING > DHCP > DHCPv6 Relay > Add/Edit
The following table describes the labels in this screen.
Remote ID This field displays whether the remote-ID option is added to DHCPv6 requests from clients in this
VLAN.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Add/Edit Click Add/Edit to add a new entry or edit a selected one.
Delete Click Delete to remove the selected entries.
Table 189 NETWORKING > DHCP > DHCPv6 Relay (continued)
LABEL DESCRIPTION
Table 190 NETWORKING > DHCP > DHCPv6 Relay > Add/Edit
LABEL DESCRIPTION
VID Enter the ID number of the VLAN you want to configure here.
Helper Address Enter the remote DHCPv6 server address for the specified VLAN.
Interface ID Enable the switch button to have the Switch add the interface-ID option in the DHCPv6 requests
from the clients in the specified VLAN before the Switch forwards them to a DHCPv6 server.
Remote ID Enter a string of up to 64 printable ASCII characters (except [ ? ], [ | ], [ ' ], [ " ] or [ , ]) to be
carried in the remote-ID option. The Switch adds the remote-ID option in the DHCPv6 requests
from the clients in the specified VLAN before the Switch forwards them to a DHCPv6 server.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.