Chapter 32 OAM
GS1920v2 Series User’s Guide
197
32.3 OAM Setup
Use this screen to turn on Ethernet OAM on the Switch and ports and configure the related settings.
Click PORT > OAM > OAM Setup to display the configuration screen as shown.
Figure 133 PORT > OAM > OAM Setup
The following table describes the fields in the above screen.
Unsupported
OAMPDU Tx
This field displays the number of unsupported OAM PDUs sent on the port.
Unsupported
OAMPDU Rx
This field displays the number of unsupported OAM PDUs received on the port.
Table 92 PORT > OAM > OAM Status > OAM Details (continued)
LABEL DESCRIPTION
Table 93 PORT > OAM > OAM Setup
LABEL DESCRIPTION
Active Enable the switch button to enable Ethernet OAM on the Switch.
Port This field displays the port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to
set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
To Next Page
Loading...
