Chapter 31 Link Layer Discovery Protocol (LLDP)
GS1920v2 Series User’s Guide
185
31.7 Org-specific TLV Setting
Use this screen to configure organization-specific TLV settings. Click PORT > LLDP > LLDP > Org-specific
TLV Setting to display the screen as shown next.
Figure 125 PORT > LLDP > LLDP > Org-specific TLV Setting
The following table describes the labels in this screen.
System Capabilities Select the check boxes to enable or to disable the sending of System Capabilities TLVs on the
ports.
System Description Select the check boxes to enable or to disable the sending of System Description TLVs on the
ports.
System Name Select the check boxes to enable or to disable the sending of System Name TLVs on the
ports.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 84 PORT > LLDP > LLDP > Basic TLV Setting (continued)
LABEL DESCRIPTION
Table 85 PORT > LLDP > LLDP > Org-specific TLV Setting
LABEL DESCRIPTION
Port This displays the Switch’s port number.
* Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Dot1 TLV
To Next Page
Loading...
Need help?
General
