Chapter 46 Spanning Tree Protocol
GS1920v2 Series User’s Guide
271
46.2 Spanning Tree Protocol Status
The Spanning Tree Protocol status screen changes depending on what standard you choose to
implement on your network. Click SWITCHING > Spanning Tree Protocol > Spanning Tree Protocol Status
to see the screen as shown.
Figure 191 SWITCHING > Spanning Tree Protocol > Spanning Tree Protocol Status
This screen differs depending on which STP mode (RSTP, MRSTP or MSTP) you configure on the Switch. This
screen is described in detail in the section (Section 46.4 on page 272, Section 46.6 on page 276, and
Section 46.8 on page 280) that follows the configuration section for each STP mode. Use the SWITCHING
> Spanning Tree Protocol > Spanning Tree Setup screen to activate one of the STP standards on the
Switch.
46.3 Spanning Tree Setup
Use the this screen to activate one of the STP modes on the Switch. Click SWITCHING > Spanning Tree
Protocol > Spanning Tree Setup to display the screen as shown.
Figure 192 SWITCHING > Spanning Tree Protocol > Spanning Tree Setup
To Next Page
Loading...
