ZyXEL Communications GS1920v2 Series - IPv6 Global Address Setup

Chapter 22 IPv6
GS1920v2 Series User’s Guide
132
Figure 88 SYSTEM > IPv6 > IPv6 Addressing > IPv6 Link-Local Address Setup > Edit
The following table describes the labels in this screen.
22.6 IPv6 Global Address Setup
Use this screen to view and configure the interface’s IPv6 global address. Click SYSTEM > IPv6 Addressing
> IPv6 Global Address Setup to display the screen as shown next.
Figure 89 SYSTEM > IPv6 > IPv6 Addressing > IPv6 Global Address Setup
Table 43 SYSTEM > IPv6 > IPv6 Addressing > IPv6 Link-Local Address Setup > Edit
LABEL DESCRIPTION
Interface Select the IPv6 interface you want to configure.
Link-Local
Address
Manually configure a static IPv6 link-local address for the interface.
Default
Gateway
Set the default gateway IPv6 address for the interface. When an interface cannot find a routing
information for a frame’s destination, it forwards the packet to the default gateway.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.