ZyXEL Communications GS1920v2 Series User Manual

Chapter 5 Initial Setup Example
GS1920v2 Series User’s Guide
71
2 Enter 2 in the PVID field for port 1 and click Apply to save your changes back to the run-time memory.
Settings in the run-time memory are lost when the Switch’s power is turned off.
5.1.3 Configure Switch Management IP Address
If the Switch fails to obtain an IP address from a DHCP server, the Switch will use 192.168.1.1 as the
management IP address. You can configure another IP address in a different subnet for management
purposes. The following figure shows an example.
Figure 49 Initial Setup Example: Management IP Address
1 Connect your computer to any Ethernet port on the Switch. Make sure your computer is in the same
subnet as the Switch.
2 Open your web browser and enter “setup.zyxel” or “192.168.1.1” (the default IP address) in the address
bar to access the Web Configurator. See Section 4.2 on page 51 for more information.

ZyXEL Communications GS1920v2 Series Specifications

General

Brand	ZyXEL Communications
Model	GS1920v2 Series
Category	Switch
Language	English