ZyXEL Communications GS1920v2 Series - MAC Based VLAN

Chapter 49 VLAN
GS1920v2 Series User’s Guide
311
49.11.1 Add/Edit a Voice VLAN
Click Add/Edit, or select an entry and click Add/Edit in the SWITCHING > VLAN > Voice VLAN Setup
screen to display the configuration screen.
Figure 224 SWITCHING > VLAN > Voice VLAN Setup > Add/Edit
The following table describes the fields in the above screen.
49.12 MAC Based VLAN
The MAC-based VLAN feature assigns incoming untagged packets to a VLAN and classifies the traffic
based on the source MAC address of the packet. When untagged packets arrive at the Switch, the
source MAC address of the packet is looked up in a MAC to VLAN mapping table. If an entry is found,
the corresponding VLAN ID is assigned to the packet. The assigned VLAN ID is verified against the VLAN
table. If the VLAN is valid, ingress processing on the packet continues; otherwise, the packet is dropped.
Add/Edit Click Add/Edit to add a new entry or edit a selected one.
Delete Click Delete to remove the selected entry.
Table 167 SWITCHING > VLAN > Voice VLAN Setup (continued)
LABEL DESCRIPTION
Table 168 SWITCHING > VLAN > Voice VLAN Setup > Add/Edit
LABEL DESCRIPTION
OUI Address Enter the IP phone manufacturer’s OUI MAC address. The first 3 bytes is the manufacturer
identifier, the last 3 bytes is a unique station ID.
OUI Mask Enter the mask for the specified IP phone manufacturer’s OUI MAC address to determine
which bits a packet’s MAC address should match.
Enter “f” for each bit of the specified MAC address that the traffic’s MAC address should
match. Enter “0” for the bits of the matched traffic’s MAC address, which can be of any
hexadecimal characters. For example, if you set the MAC address to 00:13:49:00:00:00
and the mask to ff:ff:ff:00:00:00, a packet with a MAC address of 00:13:49:12:34:56
matches this criteria.
Description Enter a description up to 32 printable ASCII characters except [ ? ], [ | ], [ ' ], or [ " ] for the
Voice VLAN device. For example: Siemens.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.