Chapter 34 Port Setup
GS1920v2 Series User’s Guide
207
CHAPTER 34
Port Setup
34.1 Port Setup
Use this screen to configure Switch port settings. Click PORT > Port Setup > Port Setup in the navigation
panel to display the configuration screen.
Figure 140 PORT > Port Setup > Port Setup
The following table describes the labels in this screen.
Table 100 PORT > Port Setup > Port Setup
LABEL DESCRIPTION
Port This is the port index number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Active Select this check box to enable a port. The factory default for all ports is enabled. A port must be
enabled for data transmission to occur.
Name Enter a descriptive name that identifies this port. You can enter up to 128 printable ASCII
characters except [ ? ], [ | ], [ ' ] or [ " ].
Note: Due to space limitation, the port name may be truncated in some Web
Configurator screens.
To Next Page
Loading...
