Chapter 61 Error-Disable
GS1920v2 Series User’s Guide
381
61.2 Error-Disable Status
Use this screen to view whether the Switch detected that control packets exceeded the rate limit
configured for a port or a port is disabled according to the feature requirements and what action you
configure, and related information. Click SECURITY > Errdisable > Errdisable Status to display the screen
as shown.
Figure 275 SECURITY > Errdisable > Errdisable Status
The following table describes the labels in this screen.
Table 213 SECURITY > Errdisable > Errdisable Status
LABEL DESCRIPTION
Inactive-reason mode reset
Port Enter the number of the ports (separated by a comma) on which you want to reset inactive-
reason status.
Cause Select the cause of inactive-reason mode you want to reset here.
Reset Click to reset the specified ports to handle ARP, BPDU or IGMP packets instead of ignoring them,
if the ports is in inactive-reason mode.
Errdisable Status
Port This is the number of the port on which you want to configure Errdisable Status.
Cause This displays the type of the control packet received on the port or the feature enabled on the
port and causing the Switch to take the specified action.
Active This field displays whether the control packets (ARP, BPDU, and/or IGMP) on the port is being
detected or not. It also shows whether loop guard is enabled on the port.