ZyXEL Communications GS1920v2 Series User Manual

Chapter 42 Differentiated Services
GS1920v2 Series User’s Guide
260
42.3.1 Configuring DSCP Settings
To change the DSCP-IEEE 802.1p mapping click SWITCHING > QoS > Diffserv > DSCP Setting to display the
screen as shown next.
Figure 186 SWITCHING > QoS > Diffserv > DSCP Setting
The following table describes the labels in this screen.
Table 137 SWITCHING > QoS > Diffserv > DSCP Setting
LABEL DESCRIPTION
0 … 63 This is the DSCP classification identification number.
To set the IEEE 802.1p priority mapping, select the priority level from the drop-down list box.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these changes if it
is turned off or loses power, so use the Save link on the top navigation panel to save your changes to
the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.

ZyXEL Communications GS1920v2 Series Specifications

General

Brand	ZyXEL Communications
Model	GS1920v2 Series
Category	Switch
Language	English