Chapter 22 IPv6
GS1920v2 Series User’s Guide
137
22.9 DHCPv6 Client Setup
Use this screen to configure the Switch’s DHCP settings when it is acting as a DHCPv6 client. Click SYSTEM
> IPv6 > DHCPv6 Client Setup to display the screen as shown next.
Figure 95 SYSTEM > IPv6 > DHCPv6 Client Setup
The following table describes the labels in this screen.
22.9.1 Edit DHCPv6 Client
Use this screen to configure the Switch’s DHCP settings when it is acting as a DHCPv6 client. Select an
entry and click Edit in the SYSTEM > IPv6 > DHCPv6 Client Setup screen to display this screen.
Figure 96 SYSTEM > IPv6 > DHCPv6 Client Setup > Edit
Table 50 SYSTEM > IPv6 > DHCPv6 Client Setup
LABEL DESCRIPTION
Index This is the interface index number.
Interface This is the name of the IPv6 interface you created.
IA-NA This field displays whether the Switch obtains a non-temporary IP address from the DHCPv6 server.
Rapid-Commit This field displays whether the Switch obtains information from the DHCPv6 server by a rapid two-
message exchange.
DNS This field displays whether the Switch obtains DNS server IPv6 addresses from the DHCPv6 server.
Domain-List This field displays whether the Switch obtains a list of domain names from the DHCP server.
Information
Refresh
Minimum
This field displays the time interval (in seconds) at which the Switch exchanges other configuration
information with a DHCPv6 server again.
Select an entry’s check box to select a specific entry.
Edit Click Edit to edit the selected entry.
To Next Page
Loading...
Need help?
General
