ZyXEL Communications GS1920v2 Series - Reset the Switch; Log Out of the Web Configurator

Chapter 4 Web Configurator
GS1920v2 Series User’s Guide
67
6 Forget the password and/or IP address.
7 Prevent all services from accessing the Switch.
8 Change a service port number but forget it.
9 You forgot to log out of the Switch from a computer before logging in again on another computer.
Note: Be careful not to lock yourself and others out of the Switch.
4.7 Reset the Switch
If you lock yourself (and others) from the Switch or forget the administrator password, you will need to
reload the factory-default configuration file or reset the Switch back to the factory defaults.
4.7.1 Restore Button
Press the RESTORE button for more than 7 seconds to have the Switch automatically reboot and restore
the factory default file. See Section 3.3 on page 47 for more information about the LED behavior.
4.7.2 Restore Custom Default
Press the RESTORE button for 3 to 7 seconds to have the Switch automatically reboot and restore the last-
saved custom default file. See Section 3.3 on page 47 for more information about the LED behavior.
4.7.3 Reboot the Switch
Press the RESET button to reboot the Switch without turning the power off. See Section 3.3 on page 47 for
more information about the LED behavior.
4.8 Log Out of the Web Configurator
Click Logout in a screen to exit the Web Configurator. You have to log in with your password again after
you log out. This is recommended after you finish a management session for security reasons.
Figure 45 Logout button
4.9 Help
The Web Configurator’s online help has descriptions of individual screens and some supplementary
information.