Chapter 22 IPv6
GS1920v2 Series User’s Guide
130
22.4 IPv6 Interface Setup
Use this screen to view and configure an IPv6 interface you create in the SYSTEM > Interface Setup
screen. Click SYSTEM > IPv6 > IPv6 Interface Setup to display the screen as shown next.
Figure 85 SYSTEM > IPv6 > IPv6 Interface Setup
The following table describes the labels in this screen.
22.4.1 Edit an IPv6 Interface
Use this screen to turn on or off an IPv6 interface you create in the SYSTEM > Interface Setup screen.
Select an entry and click Edit in the SYSTEM > IPv6 > IPv6 Interface Setup screen to display the screen as
shown next.
Figure 86 SYSTEM > IPv6 > IPv6 Interface Setup > Edit
The following table describes the labels in this screen.
Table 40 SYSTEM > IPv6 > IPv6 Interface Setup
LABEL DESCRIPTION
Index This is the interface index number.
Interface This is the name of the IPv6 interface you created.
Active This field displays whether the IPv6 interface is activated or not.
Address
Autoconfig
This field displays whether stateless auto-configuration is enabled on the interface.
Select an entry’s check box to select a specific entry.
Edit Click Edit to edit the selected interface.
Table 41 SYSTEM > IPv6 > IPv6 Interface Setup > Edit
LABEL DESCRIPTION
Interface Select the IPv6 interface you want to configure.
Active Enable the switch button to enable the interface.
Address
Autoconfig
Select this option to allow the interface to automatically generate a link-local address through
stateless auto-configuration.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
To Next Page
Loading...
Need help?
General
