ZyXEL Communications GS1920v2 Series User Manual

Chapter 32 OAM
GS1920v2 Series User’s Guide
199
The following table describes the fields in the above screen.
Table 94 PORT > OAM > OAM Remote Loopback
LABEL DESCRIPTION
Remote Loopback Test
Port Enter the number of the port from which the Switch performs a remote-loopback test.
Number of Packet Define the allowable packet number of the loopback test frames.
Packet Size Define the allowable packet size of the loopback test frames.
Test Click Test to begin the test.
Remote Loopback Mode
Port Enter the number of the port from which the Switch sends loopback control PDUs to initiate
or terminate a remote-loopback test.
Start Click Start to initiate a remote-loopback test from the specified port by sending Enable
Loopback Control PDUs to the remote device.
Stop Click Stop to terminate a remote-loopback test from the specified port by sending Disable
Loopback Control PDUs to the remote device.

ZyXEL Communications GS1920v2 Series Specifications

General

Brand	ZyXEL Communications
Model	GS1920v2 Series
Category	Switch
Language	English