Chapter 4 Web Configurator
GS1920v2 Series User’s Guide
61
Logins This link takes you to a screen where you can change the system login password, as well as con-
figure up to four login details.
SNMP This link takes you to screens where you can specify the SNMP version and community (password)
values, configure where to send SNMP traps from the Switch, enable loopguard/errdisable/poe/
linkup/linkdown/lldp/transceiver-ddm/storm-control on the Switch, specify the types of SNMP
traps that should be sent to each SNMP manager, and add/edit user information.
Switch Setup This link takes you to a screen where you can set up global Switch parameters such as VLAN type.
Syslog Setup This link takes you to a screen where you can configure the Switch’s system logging settings and
configure a list of external syslog servers.
Time Range This link takes you to a screen where you can configure time range for time-oriented features like
Classifier.
PORT
Green Ethernet This link takes you to a screen where you can configure the Switch to reduce port power con-
sumption.
Link Aggrega-
tion
This link takes you to a screen where you can logically aggregate physical links to form one logi-
cal, higher-bandwidth link.
LLDP Click the link to unfold the following sub-link menu.
LLDP This link takes you to screens where you can view LLDP information and configure LLDP and TLV
settings.
LLDP MED This link takes you to screens where you can configure LLDP-MED parameters.
OAM This link takes you to screens where you can enable Ethernet OAM on the Switch, view the config-
uration of ports on which Ethernet OAM is enabled and perform remote-loopback tests.
PoE Setup For PoE models.
This link takes you to a screen where you can set priorities, PoE power-up settings and schedule so
that the Switch is able to reserve and allocate power to certain PDs.
Port Setup This link takes you to a screen where you can configure settings for individual Switch ports.
SWITCHING
Layer 2 Proto-
col Tunneling
This link takes you to a screen where you can configure L2PT (Layer 2 Protocol Tunneling) settings
on the Switch.
Loop Guard This link takes you to a screen where you can configure protection against network loops that
occur on the edge of your network.
Mirroring Click the link to unfold the following sub-link menu.
Mirroring This link take you to a screen where you can copy traffic from one port or ports to another port in
order to examine the traffic from the first port without interference.
Multicast Click the link to unfold the following sub-link menu.
IPv4
Multicast
This link takes you to screen where you can configure various IPv4 multicast features, IGMP snoop-
ing, filtering and create multicast VLANs.
IPv6
Multicast
This link takes you to screen where you can configure various IPv6 multicast features, MLD snoop-
ing-proxy, filtering and create multicast VLANs.
MVR This link takes you to screens where you can create multicast VLANs and select the receiver ports
and a source port for each multicast VLAN.
Static
Multicast
Forwarding
By MAC
This link takes you to a screen where you can configure static multicast MAC addresses for port(s).
These static multicast MAC addresses do not age out.
PPPoE Interme-
diate Agent
This link takes you to screens where you can enable PPPoE (Point-to-Point Protocol over Ethernet)
Intermediate Agent and configure per-port, per-port-per-VLAN settings.
QoS Click the link to unfold the following sub-link menu.
Table 11 Navigation Panel Links (continued)
LINK DESCRIPTION
To Next Page
Loading...
