Chapter 12 Neighbor
GS1920v2 Series User’s Guide
97
Location This shows the geographic location of the neighbor device. This field will show “–” for
devices that do not support the ZON utility.
Desc. This shows the description of the neighbor device’s port which is connected to the
Switch.
IPv4 This shows the IPv4 address of the neighbor device. The IPv4 address is a hyper link that
you can click to log into and manage the neighbor device through its Web Configurator.
IPv6 This shows the IPv6 address of the neighbor device. The IPv6 address is a hyper link that
you can click to log into and manage the neighbor device through its Web Configurator.
Restore Click this button to restore the neighbor device to its factory default settings. A warning
message “Are you sure you want to load factory default?” appears prompting you to
confirm the action. After confirming the action a count down button (from 5 to 0) starts.
Note:
• The Switch must support power sourcing (PSE) or the network device is a powered
device (PD).
• If multiple neighbor devices use the same port, the Reset button is not available.
• You can only reset Zyxel powered devices that support the ZON utility.
Flush Click the Flush button on the port tab to remove information about neighbors learned on
a specific ports.
Flush All Click the Flush All button to remove information about neighbors learned on all ports.
Table 19 MONITOR > Neighbor > Neighbor Details (continued)
LABEL DESCRIPTION
To Next Page
Loading...
Need help?
General
