150 CHAPTER 4: PLANNING THE 3COM MOBILITY SYSTEM
8 In the IP Address box, type the IP address for the access point.
If you specify an IP address, you can use Telnet and a Web browser with
this access point.
9 In the Telnet Port Number box, specify the port number for Telnet service.
10 In the HTTP Port Number box, specify the port number for HTTP service.
11 In the Floor list, select the floor on which the access point is located.
The list shows the floors you created.
12 Do one of the following:
■ To close the wizard and save the changes, click Finish.
■ To configure radio attributes, see “Configuring Radio Attributes” on
page 150.
Configuring Radio Attributes
To configure radio attributes:
1 In the Create Third-Party AP wizard, after placing a third-party access
point, click Next.
2 Verify the radio slot number and radio type.
For a dual-radio access point, 802.11b/g radios have a slot number of 1.
802.11a radios have a slot number of 2.
To Next Page
Loading...
