Configuring WX Management Services 219
Here is an example of the Log page in the WX Switch wizard.
2 Configure logging to the local buffer on the WX:
a To enable logging to the local buffer on the WX, select Enabled. To
disable the option, clear Enabled.
b In the Severity Filter list, select the lowest level of severity to be logged:
■ Emergency — The WX is unusable.
■ Alert — Action must be taken immediately.
■ Critical — You must resolve the critical condition. If you do not
resolve the condition, the WX can reboot or shut down.
■ Error — The WX is missing data or unable to form a connection.
■ Warning — A possible problem exists.
To Next Page
Loading...
