240 CHAPTER 5: CONFIGURING WX SYSTEM AND ADMINISTRATIVE PARAMETERS
route command output shows that the static route is down. For more
information about these commands, see the Wireless LAN Switch and
Controller Command Reference.
To create a static route
1 Do one of the following:
■ Open the WX Switch wizard, then select IP Routes under IP Services in
the organizer list of the System and Administrative page.
■ In the Organizer panel, select IP Services under a WX switch or
Domain Policies, then select Edit > Properties. The Modify IP Services
wizard appears.
Here is an example of the IP Routes page in the WX Switch wizard.
2 Select New Static Route. The Create Static Route dialog box appears.
To Next Page
Loading...
