Configuring IP Services 241
3 In the Destination IP Address box, type the destination IP address and
subnet mask in classless interdomain routing (CIDR) notation (for
example, 10.10.0.0/16).
4 In the Gateway box, type the IP address of the gateway that the route
uses.
5 In the Metric box, specify the cost for using the route (0 to
2,147,483,647). Lower-cost routes are preferred. The default is 1.
6 To close the Create Static Route dialog box, click Finish.
Configuring Default Routes
You can configure a maximum of four default routes. You must specify a
default route before the WX can be managed from an arbitrary remote IP
subnetwork.
To configure a default route:
1 Do one of the following:
■ Open the WX Switch wizard, then select IP Routes under IP Services in
the organizer list of the System and Administrative page.
■ In the Organizer panel, select IP Services under a WX switch or
Domain Policies, then select Edit > Properties. The Modify IP Services
wizard appears.
To Next Page
Loading...
