248 CHAPTER 5: CONFIGURING WX SYSTEM AND ADMINISTRATIVE PARAMETERS
Setting NTP Properties
To set NTP properties:
1 Do one of the following:
■ Open the WX Switch wizard, then select NTP under IP Services in the
organizer list of the System and Administrative page.
■ In the Organizer panel, select IP Services under a WX switch or
Domain Policies, then select Edit > Properties. The Modify IP Services
wizard appears. Click on NTP at the top of the wizard.
Here is an example of the NTP page in the WX Switch wizard.
2 To enable NTP, select Enabled. To disable NTP, clear Enabled. By default,
NTP is disabled.
3 If you disabled NTP in step 2, go to step 5. Otherwise, go to the next
step.
To Next Page
Loading...
