Configuring IP Services 249
4 To set the interval at which an NTP server is polled, specify its value in
seconds (16 to 1024) in the Update Interval box. The default is 64
seconds.
5 Do one of the following:
■ Go to “Configuring ARP”.
■ Select another item in the WX Switch wizard, if you are using this
wizard.
■ Click Finish to close the wizard and save changes.
Creating NTP Servers
To create an NTP server:
1 Do one of the following:
■ Open the WX Switch wizard, then select NTP under IP Services in the
organizer list of the System and Administrative page.
■ In the Organizer panel, select IP Services under a WX switch or
Domain Policies, then select Edit > Properties. The Modify IP Services
wizard appears. Click on NTP at the top of the wizard.
2 Click on a row in the NTP Server IP Address column.
3 Change the IP address in the row to the address of the NTP server.
4 To add more NTP servers, repeat step 1 through step 3 for every server.
You can add a total of three NTP servers.
5 Do one of the following:
■ Go to “Configuring ARP”.
■ Select another item in the WX Switch wizard, if you are using this
wizard.
■ Click Finish to close the wizard and save changes.
To Next Page
Loading...
