554 APPENDIX D: CHANGING MONITORING SERVICE PREFERENCES
The options that use SNMP trap data require the corresponding SNMP
traps to be enabled on the monitored WX switches and also require the
monitoring service to be a trap receiver for each of the WX switches. (See
“Selecting WX Switches to Monitor” on page 545.)
The data for some reports also requires monitoring options to be
enabled. For information, see the descriptions for each report in
“Generating Reports” on page 483.
Monitor tab — Activity
tab in RF Monitor
window
The Activity tab at the bottom of the window
receives data from the Collect radio activity
traps option, which uses these SNMP traps
received by the monitoring service from
monitored WX switches:
■ AutoTuneRadioChannelChange
■ AutoTuneRadioPowerChange
■ CounterMeasureStart
■ CounterMeasureStop
Disabled
Monitor tab —
RF Trends window
Collect radio activity traps option Disabled
Enable RF trending option Disabled
Rogue Detection tab Enable Rogue Detection option, which
activates polling and uses these SNMP traps
received by the monitoring service from
monitored WX switches:
■ RogueDetect
■ RFDetectRogueDisappear
Disabled
Collect radio activity traps option, which
uses these SNMP traps received by the
monitoring service from monitored WX
switches:
■ CounterMeasureStart
■ CounterMeasureStop
Disabled
Performance
Monitoring window
Statistics data received by 3WXM client directly
from managed WX switches. The monitoring
service does not provide this data.
Enabled
Table 95 Sources of Monitor Data (continued)
3WXM Client Display Data Source Default
To Next Page
Loading...
