Fault tracing 291
2003
SAFE TORQUE
OFF
Programmable
fault: 46.05 STO
DIAGNOSTIC
Safe torque off function is
active, that is, safety circuit
signal(s) connected to
connector X6 is lost while
the drive is stopped and
parameter 46.05 STO
DIAGNOSTIC is set to
Alarm.
Check safety circuit connections.
For more information, see the
appropriate drive Hardware
manual.
2004
STO MODE
CHANGE
Error in changing Safe
torque off supervision, ie,
parameter 46.05 STO
DIAGNOSTIC setting
could not be changed to
value Alarm.
Contact your local ABB
representative.
2005
MOTOR
TEMPERATURE
Programmable
fault: 46.07 MOT
TEMP PROT
Measured motor
temperature has exceeded
the alarm limit defined with
parameter 46.09 MOT
TEMP ALM LIM.
Check that the actual number of
sensors corresponds to the value
set with parameter 46.08 MOT
TEMP SOURCE.
Check motor ratings and load.
Let the motor cool down. Ensure
proper motor cooling: Check the
cooling fan, clean cooling surfaces,
etc.
Check the value of the alarm limit.
2006
EMERGENCY OFF Drive has received an
emergency OFF2
command.
To restart the drive, activate the
Run enable signal (source selected
by parameter 10.80 LIFT RUN
ENABLE) and start the drive.
2007
RUN ENABLE No Run enable signal is
received.
Check the setting of parameter
10.80 LIFT RUN ENABLE. Switch
the signal (eg, digital input) on or
check the wiring of the selected
source.
2008
ID-RUN Motor identification run is
on.
This alarm belongs to the normal
start-up procedure. Wait until the
drive indicates that motor
identification is completed.
Motor identification is
required.
This alarm belongs to the normal
start-up procedure.
Select how motor identification
should be performed, parameter
99.10 IDRUN MODE.
Start identification routines by
pressing the Start key.
Code Alarm Cause What to do
To Next Page
Loading...
Need help?
General
