Program steps and cycles | Recess cycles
Tool path description:
The tool initially moves to the Start Point, offset by the
Clearance distance
The roughing passes are optional. If the roughing feed rate is 0,
the rough passes are skipped.
The amount of material machined on each rough pass is
determined by the system and will not exceed the specified
Pass value
The contour is machined at the feed rate programmed in the
step. When the tool plunges directly into the material at full
width, the full cut override is applied to the feed.
If a Finish allowance is specified, the programmed amounts are
left on the X and Z surfaces to be removed on the finish pass
The tool returns to the Start Point after completing the rough
passes
The Finish pass is optional. If finish Feed is 0, the Finish pass is
skipped.
The direction of the finish pass matches the direction of the
programmed contour
The tool returns to the Start Point after the finish pass
completes
If the approach move interferes with the part or
fixturing, it may be necessary to program a Position
step to position the tool on the proper side of the part or
fixture prior to the Recess Contour path.
8
ACU-RITE | TURNPWR | User's Manual | 08/2020
133
To Next Page
