Program edit mode | Program management
5.3 Program management
Saving a program
When creating programs, they can be saved within the control's
User folder, on a USB device, or to a network location. A graphic
view of the program is displayed in the Preview Window if it has
been run successfully.
Programs can be organized in the control, on a USB device,in a
network location, or in personalized folders that the operator can
create.
To save the current program for the first time:
Press the Program Functions soft key
Press the Save/Create soft key
The keyboard should automatically be displayed with the cursor in
the Program Name field. For additional information, see "Keyboard",
Page 30.
Naming a program
Before you can save a program, the control requires it to be named.
Enter the program name using the Arrow keys to navigate the
keyboard. Highlight the key to be used (e.g. letter, or number), then
press the enter key to add the selection into the Program Name
Field. Continue in the same manner until the name is complete.
To add numbers to your program name, press any of the number
keys on the numerical keypad, or from the keyboard display.
Press the Save/Create soft key
The control will store the program in the folder that had been
previously selected.
A message will alert you if the program was not saved properly, or
if the name that you’ve chosen already exists.
Back up programs regularly to avoid accidental loss (e.g. USB
device, or to a network location).
Deleting a program
Press the Change Window soft key to select the Folder
Contents window
Highlight the desired program
Press the Function soft key
Select Delete from the popup menu
Press the Yes soft key to erase the program
or
Press the No soft key to cancel
5
ACU-RITE | TURNPWR | User's Manual | 08/2020
79
To Next Page
Loading...
