DRO mode | Overview
4
4.1 Overview
The control is in either DRO mode or PGM mode. DRO mode
allows data input for short one step machining operations. Manual
operation, single step operation, and single commands can be
entered.
DRO mode also allows the running of programs, see "DRO cycles",
Page 57.
The following describes the concepts, and formats used with the
control which are being introduced in this chapter.
DRO screen
Status bar display
Move tool
Turning functions
Zeroing an axis
Teach position
Diameter/Radius mode
Turning function keys
DRO turning cycles
48
ACU-RITE | TURNPWR | User's Manual | 08/2020
To Next Page
Loading...
