DRO mode | DRO cycles
4.10 DRO cycles
The following explains a few of the machining operations that are
available. This example is providing an overview to the operator of
the control's capabilities.
The RECESS or TURN keys as an example access popup menus to
further refine the type of turning to be completed. Selecting the
type of operation required will open the dialogue for that type of
turning operation.
An operation is run by pressing the GO key. The STOP key can be
pressed at anytime to pause or cancel an operation.
The following one step functions are available:
Threading cycles
Thread
Thread taper
Recess cycles
Recess turn
Recess face
Turning cycles
Shoulder turn
Shoulder face
Plunge turn
Plunge face
Other cycles
Set tool
Line
Arc
4
ACU-RITE | TURNPWR | User's Manual | 08/2020
57
To Next Page
Loading...
