U511 User’s Manual Getting Started
Version 1.1 Aerotech, Inc. 2-7
2.7. Enabling and Moving an Axis
After performing the initial configurations, it is important to verify everything functions
properly. Enable and jog the axis from the Jog screen under the MDI screen. It is
recommended to initiate movement of the axis in “Freerun-low speed” mode. Also, check
the home cycle by pressing the home button.
2.8. Internal System Wiring
The U511 wiring varies depending on the AC input voltage, number of axes, DC bus
voltage, and drive modules. A system wiring drawing is provided with the documentation
package for the U511. The system drawing contains information concerning fuse values
and some jumper settings.
Additional information about the U511 is located on the system serial label and AC
power tag (located on the rear of the U511). The serial label contains the customer order
number (required when calling customer service), system drawing number, and system
part number. The AC power tag includes AC power requirements, line voltage, and
current requirements.
∇ ∇ ∇
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
