U511 User’s Manual The User Interface
Version 1.1 Aerotech, Inc. 3-33
There are five functions at the bottom of the screen. These are described below.
F1 High/Low This function selects high or low speed.
F2 Index/Freerun This function selects index or freerun mode.
F3 Enable/Disable This function will enable or disable the axis.
F4 Home This function will Home the selected axis.
F5 Quit Quit exits the Jog screen.
3.8.3. MDI Menu: Commands Submenu
This screen is for menu-assisted command entry. Essentially it is the same screen as the
Command Edit screen under the Program: Edit submenu. Refer to Section 3.4.2: Program:
Menu: the Edit Submenu to receive instructions on using the Commands screen.
∇ ∇ ∇
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
