Aerotech UNIDEX 511 - Page 77

Parameters U511 User’s Manual
4-2 Aerotech, Inc. Version 1.1
Table 4-1. U511 Parameters Grouped by Page (continued)
Parameter
Number
Description Default Value Found on
Page #
606 “Global subroutine file” GLBSUB.PRG 4-8
607 “PSO-PC firmware file” None 4-8
15 “PSO-PC DPRAM address” (hex address 0xnnnn) 0xD800 4-8
16 “PSO-PC I/O address” (hex address 0xnnn) 0 4-9
98 “Safe zone output bit 0,1-8” 0 4-9
99 “Option board setup code” 0 4-9
500 “User interrupt setup code” 0 4-10
90, 92, 94, 96 “A/D channel n joystick deadband” 0 4-10
91, 93, 95, 97 “A/D channel n center” 0 4-11
647 “Enable speaker” (y/n) No 4-11
648 “Password” None 4-12
501 “Abort on input high 0, 1-16” 0 4-12
Pages 2 and 3: Serial Port #n Setup
4-13
608, 617 “Baud rate” (bits per second) 9600 4-13
609, 618 “Data bits” (bits) 8 4-13
610, 619 “Stop bits” (bits) 1 4-13
611, 620 “Parity” (N, O, E) N 4-13
612, 621 “End of string character” 10 4-13
613, 622 “Fast output?” (y/n) Yes 4-13
614, 623 “Command ACK character” 6 4-14
615, 624 “Command NAK character” 21 4-14
616, 625 “Default configuration” 0 4-14
Page 4: GPIB/IEEE - 488 Setup
4-15
626 “GPIB address” (0-30) 2 4-15
627 “EOS character” 10 4-15
628 “Parallel Pol Response bit” (0-NONE or 1-8) 0 4-15
629 “Time out” (seconds) 30 4-15
630 “Default configuration” 0 4-15
Page 5: Axis Configuration
4-16
x00 “Metric conversion factor” (mach. steps/program step) 1.0 4-16
x01 “English conversion factor” (mach. steps/program step) 1.0 4-16
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com