140 1100 Series Nano Pump Service Manual
3 Repairing the Pump
The reply line will respond with RA 0000 SER followed by the module serial
number you just entered.
2 Turn off the nano pump, then on again. Then, re-boot the ChemStation. If
the serial number you have just entered is different than the original
module serial number, you will be given the opportunity to edit the
configure 1100 access screen during the re-boot of the ChemStation.
3 After boot-up, the serial number you have just entered can be seen under
the Instrument menu of the main user interface screen. The serial number of
the nano pump can also be seen by typing the following command into the
command line:
print sendmodule$ (lpmp, "ser?")
The reply line will give the serial number of the nano pump.
Replacing the Nano Pump’s Firmware
The installation of new firmware is required
• if a new version solves problems of the currently installed version.
• if the version of firmware on the new main board (NPM) after an exchange
of the board is older than the one previously installed.
To upgrade the nano pump’s firmware follow the procedures and instructions
given on the internet http://lsbu.marketing.agilent.com/start/start.asp.
To download and install always the newest available version of firmware on
your system or call your local service provider for assistance.
To Next Page
Loading...
Need help?
General
