1220 Infinity II LC System User Manual 311
Maintenance and Repair
11
Diode Array Detector (DAD)
1
Use a 4 mm hex key to unscrew the window assembly
[1] and remove the gasket [2] from the cell body.
Carefully take one of the gaskets (#6 back or # 7
front) and insert it into the cell body.
Do not mix the gasket #6 and # 7.
Gasket # 7 has the smaller hole and must be on the
light entrance side.
Verify that the gasket is positioned flat on the bottom
and the light path is not blocked.
If you removed all individual parts from the window
assembly refer to the figures in “Standard Flow
Cell” on page 352 for the correct orientation of the
parts.
2
Insert the window assembly [1] into the cell body.
To Next Page
Loading...
Need help?
General
