Maintenance and Troubleshooting 89
Troubleshooting the Protein Application
7
Symptoms (Protein)
Symptoms (Protein)
Click to go straight to the troubleshooting hints.
• “Residual Gel in Spin Filter after Centrifugation” on page 90
• “Too High Quantitation Results” on page 90
• “Too Low Quantitation Results” on page 91
• “Wrong Sizing Result” on page 92
• “Chip Not Detected” on page 93
• “Run Aborted” on page 94
• “Unexpected Run Time” on page 95
• “Additional Sample or Ladder Peaks” on page 99
• “Missing Upper Marker” on page 101
• “Broad Variability of the Lower Marker” on page 102
• “Missing Peaks” on page 103
• “Spikes” on page 104
• “Poor Reproducibility” on page 105
• “Low Signal Intensity” on page 106
• “Low Ladder Peaks” on page 107
• “Broad Peaks” on page 108
• “Baseline Dips” on page 109
• “Late Migration” on page 110
• “Error Message: No data received since 5 seconds” on page 111
To Next Page
Loading...
Need help?
General
